A
Anonymous09/15/26, 15:53No.3008362Broke crank bolt
Wtf do I do here? First thought is to start drilling from small to large. Fker before me used locktite ffs. Give me some ideas.
15
Replies
A
Anon09/15/26, 15:59No.3008364
sheeeeit
Ah, you can try drilling a hole in it, reverse tap the hole and die cut a reverse thread onto something else.
A
Anon09/15/26, 18:02No.3008373
Yeah i'd try drilling a hole and getting a torx bit to bite in it. There wont be any load on it now the head has snapped off. Heat will soften the locktite, so heat it up then try and twist it out.
A
Anon09/15/26, 19:12No.3008382
about to say you deserve your fate for using locktite, but i guess "it wasn't you" this time
drill smaller, bolt extractor, heat, then start extracting
good luck
A
Anon09/15/26, 22:17No.3008404
I deal with this all the time.
A
Anon09/16/26, 14:11No.3008474
Where is this from? Electric bike?
To everyone saying heat it up: isn't there an oil seal behind that pulley? Made of rubber maybe
A
Anon09/16/26, 17:33No.3008483
Fuck her right in her pussy!
I removed the timing belt pulley and heated the crank around the bolt little by little with induction cause I couldn't get the flame inside the hole.
