A
Anonymous10/03/25, 01:59No.2948456
Apologies for wasting a thread on this, but I didn't see a general for furniture or stupid questions
My desk is L shaped, where each side is a seperate piece from the corner connector, and as such there's a slight 2mm height gap where they meet. That is, sadly, also precisely where I put my mouse and hand to control it, leading to any mousepads placed there feeling uneven
Is there anything I can buy (or make, despite having zero expierence with this kind of stuff and not owning power, woodworking tools, a 3d printer, or anything like that) and then cut to fit if necessary like a foam mat or plastic sheet or something, that tapers from being 2mm tall to 0mm or .5mm or something, to just even out the transition a bit, like in the OP pic here?
12
Replies
A
Anon10/03/25, 03:00No.2948464
Are the sections held together with hardware or are they just pushed together? If the latter, raise the lower section with shims under the table legs.
A
Anon10/03/25, 08:34No.2948498
use a belt sander and make it like this insteadalternatively, cut a sheet of something to fit the lowered cavity, the thickness of the pink wedge in your pic
A
Anon10/03/25, 12:41No.2948509
you already made this thread and I made diagrams showing you how to fix it and then you said you couldn't do that so I made another diagram showing how to use a kicker board and you didn't listen so stop wasting everyone's time you fucking loser retard
A
Anon10/03/25, 13:28No.2948514
>despite having zero expierence with this kind of stuff and not owning power, woodworking tools, a 3d printer, or anything like that)
use durabond on the entire top of your desk to make it flat and then put a rug over it. just requires water a bucket and a smearing device.
A
Anon10/03/25, 15:15No.2948524
Can't you just raise whatever is holding the middle and side by 2mm?
A
Anon10/04/25, 05:09No.2948669
buy a roll of tape and coat the middle (lower) section of your desk in strips of tape until it is even with the legs (higher) section of your desk. then put something flat on top of it